Stratasys J750 User Manual page 94

Stratasys J750 User Guide
10. Click Next to begin the material replacement process in the printer.
Symbols:
The correct cartridge is in this slot.
No cartridge (or the incorrect cartridge) is in this slot.
The cartridge in this slot has insufficient weight to complete the material
11. Replace material cartridges as necessary, according to the instructions in
12. Click Start.
13. Read the warning message, and click OK.
If you continue, you must complete the material replacement process before
you can produce models. To replace material cartridges at another time, click
Cancel. If you continue (by clicking OK) and you do not complete the process,
you will need to run the wizard again before producing models.
DOC-08010 Rev. E
❒ Full. Use this cycle when the printed models must have the exact color
of the new material.
The wizard thoroughly flushes o f the feed tubes and print heads
needed for printing, based on your selections in the previous screens.
The Cartridge positioning screen appears, showing you the new location
of all cartridges in the material cabinet.
Figure 6-12 Cartridges placement
replacement process.
The expiration date of the cartridge in this slot has passed.
the wizard screen.
6 Operating and Maintaining the J750 3D Printer
6-15