Stratasys J750 User Manual page 158

Stratasys J750 User Guide
13. In the wizard screen, confirm that you have replaced the UV lamp(s) and
DOC-08010 Rev. E
that the black strip is attached, then click Next.
Figure 6-125 UV-installation confirmation screen
The wizard operates the UV lamps and checks if their power is within the
acceptable range for each printing mode.
Note: The mode currently being checked appears in the lower-left corner of
the printer interface.
Figure 6-126 Status screen during UV lamp check
6 Operating and Maintaining the J750 3D Printer
6-79