Stratasys J750 User Manual page 143

Stratasys J750 User Guide
3. In the following screen, select the UV sensor and measuring device to be
UV Measuring Device
When you use the Stratasys UV sensor box (TOL-03005-S), you connect it to
the printer. The wizard automatically measures and calibrates the UV
radiation.
If you use a stand-alone UV radiation meter, you need to manually enter the
readings from the meter in the wizard screens.
4. Make sure that the build tray is empty. Confirm this in the wizard screen
➢ When using a Stratasys UV sensor box that you connect to the printer
➢ When using a stand-alone UV radiation meter, continue with "External
DOC-08010 Rev. E
used.
Figure 6-93 UV device selection
and click Next.
Figure 6-94 Printer preparation
(TOL-03005-S), continue with "UV Sensor Connected to Printer" on the
next page.
UV Meter" on page 6-67.
6 Operating and Maintaining the J750 3D Printer
6-64