Printing Modes 5 - Stratasys Objet1000 Plus User Manual

Objet1000 Plus User Guide
DOC-06810 Rev. B
The wizard operates the UV lamps and checks if their power is within the
acceptable range for each printing mode.
Note: The mode currently being checked appears in the lower-left corner of
the printer interface.
Figure 6-112 Status during UV lamp check
After replacing a UV lamp, it is recommended that you calibrate its power.
The next screen allows you to continue to the UV Calibration wizard (see
"Testing and Calibrating the UV Lamps" on page 1).
Figure 6-113 Final wizard screen
6 Operating and Maintaining the Objet1000 Plus 3D Printer
6-71