Stratasys J750 User Manual page 157

Stratasys J750 User Guide
10. Insert the new UV lamp/reflector unit into the housing next to the print
11. Replace the UV lamp cover by inserting it into the slot on the bottom of
12. Reconnect the power and heat fuse connectors.
DOC-08010 Rev. E
block.
Figure 6-122 Print block and UV lamp assembly, showing correct
placement of black strip
the housing, and tighten the securing screw on top.
Figure 6-123 Replacing the UV lamp cover
Figure 6-124 Connecting the UV lamp
6 Operating and Maintaining the J750 3D Printer
6-78