Stratasys J750 User Manual page 86

Stratasys J750 User Guide
When printing begins, PolyJet Studio sends seven slices to the printer-control
application. This is the standard buffer between PolyJet Studio and the
printer. As each slice is printed, another slice is sent to the printer.
Depending on the size of the model(s) to be produced, printing can take
between several hours to several days. As long as there is enough Model and
Support material in the supply cartridges, printing proceeds automatically
until the job is finished.
The J750 printer uses up to six different Model-material cartridges to produce
models. In addition, two S upport-material cartridge are required. If additional
cartridges are installed and they are not needed for the current print job, the
printer interface indicates which are being used:
• Blue cartridge—used for the print job
• Gray cartridge—not used for the print job
You can monitor printer status indicators by switching the printer interface
display. To do this, click the display toggle button on the printer interface
screen.
Figure 6-4 Printer indicators
DOC-08010 Rev. E
6 Operating and Maintaining the J750 3D Printer
6-7