Stratasys J750 User Manual page 113

Stratasys J750 User Guide
Warning: Hot Surface
The print head orifice plates (bottom surface) may be hot. Do not touch them
with your bare hands, and proceed with caution.
5. Place the mirror on the build tray.
6. Put on the gloves.
Caution
Uncured printing material on the print heads might cause skin irritation. Use
disposable cleaning gloves to protect your hands.
7. Soak the cleaning cloth with alcohol.
8. Clean the orifice plates, with a back-and-forth motion. Use the mirror to
9. After cleaning the print heads, clean the entire roller surface, by rotating it
10. Clean the glass lens on the UV lamps.
11. Using a generous amount of alcohol on the cleaning cloth, remove any
DOC-08010 Rev. E
make sure that you have removed all of the residue material.
Figure 6-38 Cleaning the heads
as you clean.
material remaining on the wiper and the surrounding area.
6 Operating and Maintaining the J750 3D Printer
6-34