Stratasys J750 User Manual page 162

Stratasys J750 User Guide
Test List
Test Name
This column lists all of the tests, together with selection check boxes.
Click the check boxes to select the tests you want to run. To remove a
selection, click the check box again. To quickly select all of the tests in a
component category, use the Group drop-down list at the bottom of the
screen.
Group
This column shows the component categories for each test.
This tells you which tests are run when selecting a category from the Group
drop-down list at the bottom of the screen.
Status
This column shows the results of each test after you run it:
Test Selection Area
In the Test Selection area, at the bottom of the screen, you can quickly select
or de-select tests by their characteristics:
All
None
Unknown
Group
Selection Set
Running Built-in
To run the selected tests:
Tests
➢ Click
After you run a test, the Save and View command buttons are added to the
Built In Tests screen.
DOC-08010 Rev. E
Test successfully completed.
Test failed.
Unknown results. (The test has not been run yet.)
Click to select all of the tests in the list.
Click to de-select all of the tests in the list.
Click to select all test that have not been run yet (Status = ?).
Use this menu to select tests by component category.
Use this menu to select a pre-configured set of tests to run at
specified times (computer startup, before printing, etc.).
.
6 Operating and Maintaining the J750 3D Printer
6-83