Stratasys J750 User Manual page 114

Stratasys J750 User Guide
12. Remove any pieces of waste material collected in the purge unit. If
Note: When returning the waste collector to the purge unit, make sure to insert it
as shown.
13. Inspect the wiper.
14. When you have finished cleaning, select the confirmation check boxes in
15. Remove the cleaning materials from the printer and close the printer
16. Select the confirmation check boxes in the wizard screen and click Next.
17. Click Done to close the wizard.
DOC-08010 Rev. E
necessary, remove the waste collector to clean it. Wipe the rubber seal.
Figure 6-39 Purge unit waste collector
If the wiper is scratched, torn or worn, or if you cannot clean it
completely, replace it.
a. Grasp it and pull it up and out of its bracket.
b. Insert the new wiper blade, making sure that it is straight and secured
well on both sides.
the wizard screen (see Figure 6-37) and click Next.
cover.
The head-purge cycle begins. When this is complete, the final wizard
screen appears.
Figure 6-40 Cleaning wizard—final screen
6 Operating and Maintaining the J750 3D Printer
6-35