Stratasys J750 User Manual page 14

Stratasys J750 User Guide
Safety Guidelines
The following general guidelines, together with the instructions provided
throughout this user guide, ensure user safety while operating and
maintaining the system. If the system is not operated as specified,
the user's safety may be compromised.
Printer
➢ Installation and removal of the printer should only be done by qualified
Installation
➢ Connect the printer (and the UPS unit) to the electric outlet using a power
➢ The electric outlet should be easily accessible, near the printer.
➢ Never connect the power plug to an outlet that does not have a ground
➢ The following safety statement is followed by translations to Finish,
➢ Leave a minimum of 15 centimeters between ventilation openings and
Printer
➢ The printer should only be operated by persons trained by a Stratasys
Operation
➢ All persons operating or maintaining the printer should know the location
➢ Keep fingers and other body parts clear of the printer cover when closing
➢ Never attempt to open the printer cover while it is working.
➢ Never override the interlock safety switch.
➢ If the interlock safety switch ever fails, do not use the printer.
➢ Several parts of the printer remain extremely hot even after it has stopped
DOC-08010 Rev. E
service personnel.
cord that is safety-certified.
(earth) wire, and never disconnect the ground. Doing so might expose the
operator to serious danger from electric shock.
Norwegian, Swedish and Danish, as required by local regulations:
"The machine must be connected to a grounded power outlet."
❒ FI: Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
❒ NO: Apparatet må tilkoples jordet stikkontakt.
❒ SE: Apparaten skall anslutas till jordat uttag.
❒ DK: Apparatets stikprop skal tilsluttes en stikkontakt med jord, som
giver forbindelse til stikproppens jord.
walls or other objects.
customer-support representative.
of first aid and emergency equipment and how to use it. Never block
access to this equipment.
it.
operating. Avoid touching the UV lamps and the print block.
2 Safety
2-4