Configuring Video And Audio Settings; Configuring Video Settings - HIKVISION E SERIES User Manual

Network speed dome

Hide thumbs Also See for E SERIES:

Table of Contents

User Manual of E Series Network Speed Dome

6.4 Configuring Video and Audio Settings

Steps:

1. Enter the Video Settings interface:

Configuration >Basic Configuration > Video / Audio > Video

Or Configuration > Advanced Configuration > Video / Audio > Video

2. Select the Stream Type of the speed dome to main stream (normal) or sub-stream.

The main stream is usually for recording and live viewing with good bandwidth, and the

sub-stream can be used for live viewing when the bandwidth is limited. Refer to the Section

6.1 Configuring Local Parameters for switching the main stream and sub-stream for live

viewing.

3. You can customize the following parameters for the selected main stream or sub-stream:

Video Type:

Select the stream type to video stream, or video & audio composite stream. The audio signal

will be recorded only when the Video Type is Video & Audio.

Resolution:

Select the resolution of the video output.

Bitrate Type:

Select the bitrate type to constant or variable.

Video Quality:

When bitrate type is selected as Variable, 6 levels of video quality are selectable.

Frame Rate:

The frame rate is to describe the frequency at which the video stream is updated and it is

measured by frames per second (fps). A higher frame rate is advantageous when there is

movement in the video stream, as it maintains image quality throughout.

Max. Bitrate:

Set the max. bitrate to 32~12288Kbps. The higher value corresponds to the higher video

Figure 6-25 Configure Video Settings

Table of Contents