Configuring Port Settings - HIKVISION E SERIES User Manual

User Manual of E Series Network Speed Dome
Before utilizing this function, you have to enable the Multicast function of your router and
configure the gateway of the network speed dome.
 If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the Preferred DNS Server and Alternate DNS server.
The router must support the route advertisement function if you select Route
Advertisement as the IPv6 mode.

6.3.2 Configuring Port Settings

Purpose:
If there is a router and you want to access the speed dome through Wide Area Network (WAN),
you need to forward the 3 ports for the speed dome.
Steps:
1. Enter
the Port Settings interface:
Configuration > Basic Configuration > Network > Port
Or Configuration > Advanced Configuration > Network > Port
Set the
2. HTTP port, RTSP port and port of the speed dome.
HTTP Port: The default port number is 80.
RTSP Port:
The default port number is 554.
Port:
HTTPS The default port number is 443.
Server Port: The default port number is 8000.
3. Click to save the settings.
© Hikvision
Figure 6-8 DNS Server Settings
Figure 6-9 Port Settings
34