HIKVISION E SERIES User Manual page 39

Network speed dome

Hide thumbs Also See for E SERIES:

Table of Contents

User Manual of E Series Network Speed Dome

 Configuring Time Synchronization by NTP Server

Steps:

(1) Check the radio button to enable the NTP function.

(2) Configure the following settings:

Server Address: IP address of NTP server.

NTP Port: Port of NTP server.

Interval: The time interval between the two synchronizing actions by NTP server. It can be

set from 1 to 10080 minutes.

You can click Test to make sure that the NTP server is connected.

If the speed dome is connected to a public network, you should use a NTP server that

has a time synchronization function, such as the server at the National Time Center (IP

Address: 210.72.145.44). If the speed dome is set in a customized network, NTP software can

be used to establish a NTP server for time synchronization.

 Configuring Time Synchronization Manually

Steps:

(1) Check the Manual Time Sync radio button.

(2) Click

to set the system time from the pop-up calendar.

(3) Click

to save the settings.

You can also check the Sync with local time checkbox to synchronize the time of the

speed dome with the time of your computer.

Figure 6-2 Time Settings

Figure 6-3 Time Sync by NTP Server

Table of Contents