User Manual of E Series Network Speed Dome
6.3 Configuring Network Settings
6.3.1 Configuring TCP/IP Settings
Purpose:
TCP/IP settings must be properly configured before you operate the speed dome over network.
IPv4 and IPv6 are both supported.
Steps:
1. Enter
TCP/IP Settings interface:
Configuration > Basic Configuration > Network > TCP/IP
Or Configuration > Advanced Configuration > Network > TCP/IP
2.
Configure the NIC settings, including the IPv4(IPv6) Address, IPv4(IPv6) Subnet Mask and
IPv4(IPv6) Default Gateway.
3.
Click
to save the above settings
You can click Test to make sure that the IP address is valid.
If the DHCP server is available, you can check
address and other network settings from that server.
The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 1500. The default value
is 1500.
The Multicast sends a stream to the multicast group address and allows multiple clients to
acquire the stream at the same time by requesting a copy from the multicast group address.
© Hikvision
Figure 6-7 TCP/IP Settings
.
to automatically obtain an IP
33