Starting The Engine; Shifting The Transmission - Can-Am Rally 200 Operator's Manual

Starting the Engine

Initial Cold Starting
Insert key in ignition switch and turn to
ON position.
NOTE: Do not forget, place the engine
stop switch to RUN position.
In cold weather, colder than 0°C
(32°F), place the choke lever to full
choke position.
V06F0QY
Press the engine start button and hold
until engine starts.
CAUTION: Do not hold the engine
start button more than 20 seconds.
A rest period should be observed
between the cranking cycles to let
starter cool down. Pay attention
not to discharge battery.
NOTE: Throttle assist may be use
to help engine starting faster. Press
the throttle lever slightly. If too much
throttle is used the choke system will
not be activated.
Release the engine start button imme-
diately when engine has started.
After a few seconds, move the choke
lever from full choke position to an in-
termediate position until the best en-
gine RPM is achieved.
NOTE: Overusing choke may flood en-
gine and make it hard to start. Refer to
SPECIAL PROCEDURES if it occurs.
When the engine is warm, push the
choke lever to OFF and release brakes.
Warm Engine Starting
Start the engine as explained above
but without the choke. If the engine
does not start after two 5-second at-
tempts with the electric starter, move
the choke lever and place it half way
position. Start the engine without ac-
tivating the throttle lever. After a few
seconds, push the choke lever to OFF
position.

Shifting the Transmission

Let engine idle to warm up.
Apply brakes and select the desired
gear range H.
Release brakes.
CAUTION: Make sure parking brake
is fully disengaged before operat-
ing the vehicle.
Gradually press the throttle lever to in-
crease engine speed and thus engag-
ing the continuously variable transmis-
sion (CVT).
At the opposite, when the throttle
lever is released, the engine speed
decreases.
Using the Reverse
CAUTION: When changing from
forward to reverse, or vice-versa,
always completely stop the vehicle
and apply the brake prior to moving
the transmission lever.
The same procedures as SHIFTING
THE TRANSMISSION above apply ex-
cept for the following.
Set the transmission lever in RE-
VERSE position.
_____________________
83