Battery Removal; Fuse Replacement; Bulb Replacement - Can-Am DS 70 Operator's Manual

Hide thumbs Also See for DS 70:
Table of Contents

Advertisement

Battery Removal

WARNING
Never charge a battery while in-
stalled in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
CAUTION: Never remove the bat-
tery sealing cap.
Clean battery post with a wire brush.
Apply dielectric grease on post to pro-
tect against oxidation.
Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
vmo2008-008-017_b
1. BLACK (-)
2. RED (+)
WARNING
Always respect this order for dis-
assembly; disconnect BLACK (-)
cable first. Fuel vapors can be
present in engine compartment
and a spark may ignite them and
possibly cause personal injuries.
Remove battery from vehicle.
_____________________
108
Installation
Reinstall battery in vehicle.
WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.

Fuse Replacement

If the fuse is damaged, replace it by
one of the same rating.
CAUTION: Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuse holder is located on the RED (+)
battery cable.
vmo2008-008-017_a
1. Fuse holder

Bulb Replacement

WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ds 902008 ds 902008 ds 70

Table of Contents