Operating Instructions; General; Pre-Operation Check - Can-Am Rally 200 Operator's Manual

Table of Contents

Advertisement

OPERATING INSTRUCTIONS

General

Transmission lever must be on NEU-
TRAL to allow engine starting.
To start engine, place the engine stop
switch to RUN position, insert key in
ignition switch and turn to the ON po-
sition then press the engine start but-
ton.
For your convenience, an override
mode allows the engine to be started
with the transmission lever in any po-
sition. Press and hold the front brake
lever while pressing the engine start
button.

Pre-Operation Check

WARNING
The pre-operation check is very
important prior to operating the
vehicle. Always check the prop-
er operation of critical controls,
safety features and mechanical
components before starting.
not done as specified here, severe
injury or death might occur.
Before using this vehicle, the operator
should always:
• Apply parking brake and check if it
operates properly.
• Check tire pressure and condition.
• Check wheels and bearings for
wear and damage.
• Check location of controls and en-
sure they work properly.
• Verify if steering operates freely.
• Activate throttle control lever sever-
al times to ensure it operates freely.
It must return to idle position when
released.
______________________
82
• Activate the brake levers and brake
pedal to make sure the brakes fully
apply. Levers and pedal must fully
return when released.
• Ensure transmission lever is work-
ing then reset in NEUTRAL position.
• Check drive chain for adjustment
and lubrication.
• Check sprockets for wear and dam-
ages.
• Check fuel, oil and coolant levels.
• Check for oil leaks on the engine
and the transmission.
• Ensure fuel valve is in fully open
position (ON).
• Clean headlamps and taillight.
• Ensure seat is properly tightened.
• If you transport cargo, respect load
capacity. Ensure cargo is properly
secured to the racks.
• If you are pulling a trailer or other
equipment, ensure it respects the
tongue capacity and towing capac-
ity. Ensure trailer is properly se-
If
cured to hitch.
• Look and feel for loose parts while
engine is off. Check fasteners.
• Ensure the path of travel is free of
persons and obstacles.
• Check operation of ignition switch,
engine start button, engine stop
switch and headlamps.
• Start engine, remove parking brake
and drive forward slowly a few feet
then apply all brakes individually to
test them.
Correct any problem you may have
found before riding. See an autho-
rized Can-Am dealer as necessary.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents