A15E0KY
TYPICAL
1. Fuse
2. Check if melted
Bulb Replacement
WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
Headlamps
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
To replace the headlamp bulb, proceed
as follows.
NOTE: On the following illustration,
the headlamp has been removed for a
better comprehension.
Remove cover screws.
1
2
vmo2006-005-043_a
1. Screws
2. Cover
Remove rubber protector over head-
lamp housing.
vmo2006-005-040_a
1. Rubber protector
2. Headlamp housing
Unplug connector from headlamp.
NOTE: Use small locking tab to unlock
connector then pull on connector.
vmo2006-005-041_a
PUSH ON LOCKING TAB TO UNLOCK
CONNECTOR
_____________________
119