Fuse; Bulb Replacement - Can-Am DS250 Operator's Manual

Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush. Battery top should be
cleaned by soft brush and any grease-
cutting soap or baking soda solution.
Installation
Reinstall battery in vehicle.
WARNING
Connect RED (+) cable first then
BLACK (-) cable. Always connect
RED (+) cable first.

Fuse

If fuses are damaged, replace them by
one of the same rating.
CAUTION: Do not use a higher rat-
ed fuse as this can cause severe
damage.
Fuses are located underneath the seat
in the service compartment. Remove
the seat to allow an access at the fuse
holder.
vmr2006-078-001_b
1. Fuse holder
To remove fuse from holder, unclip
and remove holder cover then pull
fuse out. Check if filament is melted.
1. Fuse
2. Check if melted

Bulb Replacement

Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
Headlamp
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
To unplug connector, release locking
tab then pull on connector using a wig-
gle movement.
_____________________
WARNING
111