vmo2006-007-031_a
REAR — FUSES LOCATION
1. (F8) Main (30 A)
(F9) Main accessories (30 A)
To remove fuse from holder, remove
the fuse holder cover then pull fuse
out. Check if filament is melted.
TYPICAL
1. Fuse
2. Check if melted
Bulb Replacement
WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
_____________________
120
Headlamps
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
To replace the headlamp bulb, proceed
as follows.
NOTE: On the following illustration,
the headlamp has been removed for a
better comprehension.
Remove cover screws.
vmo2006-005-043_a
1. Screws
2. Cover
Remove rubber protector over head-
lamp housing.
vmo2006-005-040_a
1. Rubber protector
2. Headlamp housing
Unplug connector from headlamp.
NOTE: Use small locking tab to unlock
connector then pull on connector.