Table of Contents
Advertisement
OPERATING INSTRUCTIONS
General
Transmission lever must be on NEUTRAL to
allow engine starting.
To start engine, place the engine stop switch
to RUN position, insert key in ignition switch
and turn to ON then press start button.
For your convenience, an override mode al-
lows the engine to be started with the trans-
mission lever in any position. Press and hold
the front brake lever while pressing the start
button.
Pre-Operation Check
WARNING
The pre-operation check is very important
prior to operating the vehicle. Always
check the proper operation of critical con-
trols, safety features and mechanical com-
ponents before starting. If not done as
specified here, severe injury or death
might occur.
Before using this vehicle, the operator should
always:
•
Apply parking break and check if it oper-
ates properly.
•
Check tire pressure and condition.
•
Check wheels and bearings for wear and
damage.
•
Check location of controls and ensure they
work properly.
•
Verify if steering operates freely.
•
Activate throttle control lever several times
to ensure it operates freely. It must return
to idle position when released.
•
Activate the brake lever and foot pedal to
make sure the brakes fully apply. Lever
and pedal must fully return when released.
•
Ensure transmission lever is working then
reset in NEUTRAL position.
•
Check drive chain for lubrication and ad-
justment.
•
Check sprockets for wear and damages.
•
Check fuel, oil and coolant levels.
•
Check for oil leaks on the engine and the
transmission.
•
Ensure fuel valve is in fully open position
(ON).
•
Clean headlamps and taillight.
•
Ensure seat is properly tightened.
80
•
If you transport cargo, respect load capac-
ity. Ensure cargo is properly secured to the
racks.
•
If you are pulling a trailer or other equip-
ment, ensure it respects the tongue capac-
ity and towing capacity. Ensure trailer is
properly secured to hitch.
•
Look and feel for loose parts while engine
is off. Check fasteners.
•
Ensure the path of travel is free of persons
and obstacles.
•
Check operation of ignition switch, start
button, engine stop switch and head-
lamps.
•
Start engine, remove parking brake and
drive forward slowly a few feet then apply
all brakes individually to test them.
Correct any problem you may have found be-
fore riding. See an authorized Bombardier
ATV dealer as necessary.
Initial Cold Starting
Insert key in ignition switch and turn to ON.
NOTE: Do not forget place the engine stop
switch to RUN position.
In cold weather, colder than 0°C (32°F), place
the choke lever to full choke position.
V06F0QY
Press start button and hold until engine starts.
CAUTION: Do not hold start button more than
30 seconds. A rest period should be observed
between the cranking cycles to let starter cool
down. Pay attention not to discharge battery.
Hide quick links:
Advertisement
Table of Contents
