Registering The Paper Size And Type - Canon LBP7660Cdn Manual

Registering the Paper Size and Type

This printer cannot automatically detect the paper size. Therefore, you need to register the size of the loaded paper.
Also, it is necessary to set the paper type to match the type of paper that is loaded.
Register the paper size using the following procedure. (The paper size setting is set to [A4] by default.)
NOTE
Precautions when specifying [Mixed Sizes]
The printer performs printing without checking the paper settings in the printer driver.
Make sure that the paper specified in the printer driver matches that loaded in the paper drawer before using the
printer.
If you are using the UFR II printer driver, load custom size paper whose long edges are 215.9 mm or less in
landscape orientation.
1
Press [ ] ( : Feeder Selection).
2
Select the paper source whose size is to be registered using [
Select either [MP Tray Paper Size], [Drawer 1 Size] or [Drawer 2 Size].
3
Select a paper size using [
Paper size is registered.
4
Select the paper source whose type is to be registered using [
Select either [MP Tray Paper Type], [Drawer 1 Type] or [Drawer 2 Type].
Since the printer driver's [Paper Type] default value is [Printer Default], it is normally not necessary to change the
printer driver settings.
Whenever you change the printer driver settings, match them with the paper settings on the control panel.
] and [ ], and then press [OK].
] and [ ], and press [OK].
] and [ ], and press [OK].
0258-038