Canon LBP7660Cdn Manual page 436

indicator is off).
2
Select [TCP/IP Settings] using [
3
Select [IPv4 Settings] using [
4
Set it to use [IPv4].
(1) After selecting [IPv4] using [
(2) After selecting [On] using [
5
Select the method for setting the IP address.
(1): Select [IP Mode] using [
(2): Select a method for setting the IP address using [
[Auto]:
[Manual]:
6
Set the IP address.
If You Selected [Auto] in Step 5
If You Selected [Manual] in Step 5
If You Selected [Auto] in Step 5
1. Select [Protocol] using [
2. Select [On] for the option to be used when setting the IP address.
[Use DHCP]:
[Use BOOTP]:
[Use RARP]:
NOTE
When using DHCP, BOOTP, or RARP
You can select only one from RARP, BOOTP, or DHCP. One of the following can be used: DHCP,
BOOTP, or RARP. When any of the settings is turned [On], the remaining two settings are automatically
turned [Off].
Because it takes approximately two minutes to check whether DHCP, BOOTP, and RARP are available,
we recommend that you set the unused protocol(s) to [Off].
] and [ ], and then press [OK].
] and [ ], and then press [OK].
] or [ ], press [OK].
] or [ ], press [OK].
] and [ ], and then press [OK].
When setting the IP address using any one of DHCP, BOOTP, or RARP, select this
option.
When specifying the IP address to the printer directly, select this option.
] and [ ], and then press [OK].
Obtains an IP address using DHCP. (The DHCP server needs to be running.)
Obtains an IP address using BOOTP. (The BOOTP daemon needs to be running.)
Obtains an IP address using RARP. (The RARP daemon needs to be running.)
] and [ ], and then press [OK].