Canon LBP7660Cdn Manual page 916

[MP Tray Paper Size], [Drawer 1 Size] or [Drawer 2 Size] in the [Select Feeder] menu
Specify the setting properly.
Solution "Registering the Paper Size and Type"
"Configuring the Printer Driver and Printing"
<Cause 2> When the following settings in the [Select Feeder] menu are set to [Mixed Sizes], custom
size paper whose long edges are 215.9 mm or less is loaded in portrait orientation and printed (only
when the UFR II printer driver is used).
[MP Tray Paper Size]
[Drawer 1 Size]
[Drawer 2 Size]
Solution Load the paper in landscape orientation, then print again.
<Cause 3> When the UFR II printer driver was not used, custom size paper was loaded in landscape
orientation to be printed.
Solution Load the paper in portrait orientation, then print again.
<Cause 4> [Check Paper Size] in the common [Setup] menu ([User Maintenance] options) is set to [On].
Set [Check Paper Size] to [Off], and then print again.
Solution
"[Setup] Menu ([User Maintenance] Options)"
Check toner cart. Remove packing materials.
<Cause> The toner cartridge was installed with the sealing tapes still attached.
Remove the sealing tapes and set the toner cartridge in the correct position.
Solution
"Toner Cartridge Replacement"
Close XXXX cover. (XXXX shows the cover name)
<Cause> A cover is open.
Close the cover firmly. If the printer is not online, press [
Solution
IEEE802.1X error. Set the necessary auth. information.
<Cause> There is information missing from the IEEE802.1X authentication settings.
Check the IEEE802.1X settings, and reconfigure them.
Solution
"Setting IEEE802.1X Authentication "
Image browse data error.
<Cause> Data which this printer cannot process is included in TIFF data.
Perform the following procedure.
1. Install the SD card.
Solution 1
(LBP7680Cx
2. 2Q WKH FRQWURO SDQHO VHOHFW >,PDJLQJ@
Installing SD Card
] ( : Online).
>3ULQW *XDUDQWHH@ >2Q@