Enabling the Remote UI
This section describes the procedure for enabling the Remote UI using the printer's control panel.
NOTE
When enabling the Remote UI using software other than the Remote UI
You can also enable the Remote UI using the following software.
"FTP Client"
You can enable the Remote UI by accessing the FTP server of the printer using Command Prompt.
1
Press [
] (
When the message is displayed, press [OK].
2
Select [Remote UI Settings] using [
3
Select [Remote UI] using [
4
Select [On] using [
: Settings), select [Network] using [
] and [
] and [
], and then press [OK].
] and [
], and then press [OK].
] and [
], and then press [OK].
0258-086
], and then press [OK].