Canon LBP7660Cdn Manual page 919

If [2-Sided Printing] is set to [On], specify [Off], and then print again.
Solution 4
"[Setup] Menu ([Paper Source] Options)"
Change the setting for [Halftones], and then print again.
Solution 5
"[Setup] Menu ([Quality] Options)"
Not enough system memory. <Auto Error Skip>
<Cause> The work memory required for the printer process ran out while the system was processing
the data (mainly the graphics data and text data).
Press [
Solution 1
printed properly.
Perform the following procedure.
1. Perform a soft reset.
Solution 2
2. After the soft reset, either perform a hard reset or turn the printer back ON, increase memory
capacity and print again. (All data in the memory will be erased.)
Not enough work memory. <Auto Error Skip>
<Cause> The work memory for each print mode cannot be secured.
Press [
printed properly.
Solution 1
When continuing printing by pressing [
Be aware that the data of overlay or macro that is already registered may be deleted.
Perform the following procedure.
1. Perform a soft reset.
Solution 2
2. After the soft reset, either perform a hard reset or turn the printer back ON, increase memory
capacity and print again. (All data in the memory will be erased.)
Output tray is full. Remove paper.
<Cause> The output tray is filled to the limit.
Solution Remove the paper in the output tray.
Paper is jammed.
<Cause> Paper is jammed inside the printer.
"[Setup] Menu ([Quality] Options)"
] ( : Online) to continue printing. However, the data with which an error is occurring is not
"Canceling the Process Currently Being Performed (Soft Reset)"
"Canceling All the Jobs (Hard Reset)"
] ( : Online) to continue printing. However, the data with which an error is occurring is not
IMPORTANT
"Canceling the Process Currently Being Performed (Soft Reset)"
"Canceling All the Jobs (Hard Reset)"
] ( : Online)