Canon LBP7660Cdn Manual page 589

Settings]
[Rjct Packet in
Sleep]
[Spooler]*
[Network Delay
Time]*
[Remote UI
Settings]
*
[Ethernet Driver]
[IEEE802.1X]
[Address Filter]
*
[MAC Address]
[E-Mail Print Set.]
[Init. Network Set.]
Method for entering addresses
1. Move the cursor to each field (an area separated by periods to enter three-digit numbers) in which you want to enter
the address, by pressing [
2. Enter the numbers. ([
3. After entering values in all the fields, press [OK] to confirm the settings.
Settings 5] :
[Auth. Password]
[Encryption Password]
[Off], [On]
[Off], [On]
0 to 300 seconds
[Remote UI]: [Off], [On]
* *
[SSL] : [Off], [On]
[Auto Detect]: [Off], [On]
[Communication Mode]
[Half Duplex], [Full
Duplex]
*
[Ethernet Type] : [10
Base-T], [100 Base-TX],
[1000 Base-T]
[Off], [On]
[Off], [On]
(Display only)
[POP3 RX Interval]: 0 to 90
(minutes)
[POP3 RX]: [Off], [On]
[SMTP RX]: [Off], [On]
-
] or [ ]. (The number in the field blinks, allowing you to enter a value.)
] increases the value and [
Specify the settings related to SNMP v. 3 protocol.
Specifies whether to discard the SNMP packets received
while in sleep mode.
If you set this item to [On], you may be unable to
access the printer from Canon software (iW Series)
or applications using the SNMP protocol.
When using the spooling function, set it to [On].
"Setting the Spooling Function (LBP7680Cx Only)"
Specifies the time interval from when the printer is turned
ON to when the protocol starts.
"Specifying the Setting for Startup Waiting Time"
Specifies whether the printer should use the Remote UI.
Also, whether to use SSL for communication by the Remote
UI is specified.
"Setting Keys and Certificates"
*
:
Configures the Ethernet driver.
"Changing the Network Transmission Speed or
Transfer Mode"
When using the IEEE802.1X function, set it to [On].
"Setting IEEE802.1X Authentication "
When using the address filter function, set it to [On].
"Restricting the Users Who Can Print or Perform the
Printer Settings"
"Restricting the Users Who Can Access"
Displays the MAC address of the printer.
Set e-mail print.
"Receiving E-mail Data on the Mail Server and
Printing (E-mail Print)"
By the initialization in this item, you can reset the network
settings to the default settings.
"Initializing the Network Settings"
] decreases the value.)