Cleaning The Flue System; Cleaning The Ceramic Cladding; Cleaning The Enamelled Metal Parts; Cleaning The Glass (Daily) - Piazzetta P963 Instructions For Installation, Use And Maintenance Manual

7.5 CLEANING THE FLUE SYSTEM

Until you have got reasonably used to the operating conditions of
the stove, we recommend that this maintenance be carried out on a
monthly basis.
Remove the plug from the Tee and clean the pipes.
If necessary, particularly on the fi rst few occasions, we recommend
calling in a qualifi ed technician.

7.6 CLEANING THE CERAMIC CLADDING

IThe ceramic cladding must fi rst be cleaned with a soft dry cloth before using any detergent (even mild detergent).
Products are available on the market which are suitable for cleaning ceramics as well as concentrated products for cleaning porcelain. These will
remove oil, ink, coffee and wine stains, etc.
d
Never soak the ceramic cladding or clean it with cold water when it is still hot as the thermal shock could cause it to crack.

7.7 CLEANING THE ENAMELLED METAL PARTS

When cleaning the enamelled metal parts of the product use a soft cloth moistened with water
d
Never clean metallic parts using alcohol, solvents, petroleum-based products, acetones or other degreasing or abrasive substances.
In the event of such substances being used, the manufacturer will not be responsible for any damage caused.
Discolouration of metallic parts may be the result of misuse.

7.8 CLEANING THE GLASS (DAILY)

a
The glass should be cleaned when cold using ammonia-based degreasing agents and not corrosive substances such as solvents.
Although it is likely that tar will build up on the glass during the lighting stage, it will burn off with the stove in full operation.
If, however, the tar is left to build up over a long period it will require more effort to remove.
We therefore recommend that the glass be cleaned daily before lighting the stove.
d
Do not use any material that could scratch or spoil the glass, as scratches may develop into cracks or breaks.

7.9 REPLACING THE WINDOW

The stove is fi tted with a 4 mm thick glass panel, resistant to thermal shock up to 750°C; the glass can only be broken by heavy impact or misuse.
Do not slam the door or hit the window.
In case of breakage replace only with a Gruppo Piazzetta spare part.
To replace, proceed as follows:
- wear protective gloves;
- remove the door and lie it fl at;
- loosen the screws visible on the inside of the door;
- remove the frame and glass carefully;
- if the fi breglass seal and glazing bead have deteriorated, replace them;
- change the glass panel then replace the frame, tightening the screws carefully but not excessively;
- remount the door.
If other problems occur, consult your nearest retailer.
50
Fig. 67
H07025410 / DT2000678 – 00
DT2010092-03
DT2031151-00
DT2010059-03
DT2010061-03
DT2010062-05
DT2010093-06