Stitch Selection Knob; Stitch Width/Needle Position Dial; Needle Position - ELNA 3210 Instruction Manual

Stitch Selection Knob

The needle must be at a high position before selecting a
stitch. Hand turn the flywheel toward you to raise the
needle. OR Press the Up/Down Needle key until the
needle is in an up position (Model 3230 only).
Turn the stitch selection knob until the desired stitch is
1
2
shown in LCD Screen (Model 3230 only) or Stitch
2
Selection Display 3 (Model 3210 only).
1
3
1
Model 3230 Only
If the LCD Screen only shows arrows and no stitch
information, the stitch selection knob is not positioned
correctly. Move the stitch selection knob until a stitch is
displayed.

Stitch Width/Needle Position Dial

1
The needle must be at a high position before changing
stitch width or needle position. Hand turn the flywheel
toward you to raise the needle. OR Press the Up/Down
Needle key until the needle is in an up position (Model
3230 only).
Turn the stitch width/needle position dial to align the
desired stitch width with the setting mark 1 The lower the
number, the narrower the stitch. The higher the number,
the wider the stitch. The widest width this machine can
sew is 6.5 mm.
NOTE: If the setting is "0" the machine will sew a straight
stitch (or triple seam) in center needle position.
21