Connect Devices to the cinema projector
3.2
Connect a Communications Device
protocol and is intended for Christie accessories or automation controllers only.
To communicate with the cinema projector, connect the equipment to an Ethernet hub or switch.
3.3
Connect Devices to the SCCI Port
The Simple Contact Closure Port (SCCI) port is a DB-9 (male) connector is located on the PIB input panel and
is used to control a limited set of cinema projector functionality through contact closures. This table lists the
control functions available through the SCCI:
Table 3.1 SCCI Connector Pinouts
PIN
1
2
3
4
5
6
7
3-2
The RS232 PIB port located on the PIB faceplate utilizes Christie-proprietary
Figure 3-2 Connecting Communications
SIGNAL NAME
+5V Standby
Lamp ON
+5V Standby
Lamp OFF
+5V Standby
Douser Closed
Douser Open
DIRECTION
DESCRIPTION
Out
Current limited 5VDC supply
In
cinema projector at Power On mode,
lamp is ON
Out
Current limited 5VDC supply
In
cinema projector at full power, lamp is
OFF
Out
Current limited 5VDC supply
In
Close douser
In
Douser open
CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)