Removing The Control Panel-10 Hard Drive And 24 Hard Drive System - Dell PowerEdge R630 Owner's Manual

Figure 92. Installing the control panel for eight hard drive system
1. control panel
3. display module ZIF connector
Next steps
Follow the procedure listed in the After working inside your system section.
Related Links
After working inside your system
Removing the control panel–eight hard drive system
Removing the control panel–10 hard drive and 24 hard drive system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #1 screwdriver ready.
Steps
1. Remove the screw (located at the top of the chassis) that secures the control panel to the chassis.
2. Remove the control panel cable from the connectors on the system board (J_CP and J_FP_USB) and
the hard drive expander card.
168
2. notch on chassis front wall (2)
4. display module cable