Dell PowerEdge R630 Owner's Manual page 71

Option Description
attempt fails, and the value must not be changed. This option is set to 115200 by
default.
Remote Terminal Sets the remote console terminal type. This option is set to VT 100/VT 220 by
Type default.
Redirection After Enables or disables the BIOS console redirection when the operating system is
Boot loaded. This option is set to Enabled by default.
Related Links
Serial Communication
Viewing Serial Communication
System Profile Settings
You can use the System Profile Settings screen to enable specific system performance settings such as
power management.
Related Links
System Profile Settings details
System BIOS
Viewing System Profile Settings
Viewing System Profile Settings
To view the System Profile Settings screen, perform the following steps:
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish
booting, and then restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click System Profile Settings.
Related Links
System Profile Settings
System Profile Settings details
System Profile Settings details
The System Profile Settings screen details are explained as follows:
Option Description
System Profile Sets the system profile. If you set the System Profile option to a mode other than
Custom, the BIOS automatically sets the rest of the options. You can only change
the rest of the options if the mode is set to Custom. This option is set to
Performance Per Watt Optimized (DAPC) by default. DAPC is Dell Active Power
Controller.
CPU Power Sets the CPU power management. This option is set to System DBPM (DAPC) by
Management default. DBPM is Demand-Based Power Management.
NOTE: All the parameters on the system profile setting screen are available
only when the System Profile option is set to Custom.
71