Quick Sync Indicator Codes - Dell PowerEdge R630 Owner's Manual

Quick Sync indicator codes

Figure 14. Quick Sync indicator codes
1. Quick Sync status indicator
Table 15. Quick Sync indicator codes
Power indicator pattern
Slow flash
Solid
Flashes three times rapidly and then turns off
Flashes continuously when the mobile device
touches the antenna
Flashes rapidly five times and turns off for one
second when the activation button is pressed.
This pattern is repeated until the activation
button is pressed again.
Off
Related Links
32
2. Quick Sync activation button
Condition
Indicates that Quick Sync is waiting to be configured
from iDRAC.
Indicates that Quick Sync is ready to transfer.
Indicates that the Quick Sync feature is disabled from
iDRAC.
Indicates data transfer activity.
Indicates that the Quick Sync hardware is not
responding properly. Reseat the bezel. If the problem
persists, see Getting help section.
Indicates that the Quick Sync feature is turned off.
Use the activation button to enable it. If pressing the
activation button does not turn on the LEDs, it
indicates that power is not delivered to the Quick
Sync bezel.
NOTE: For security purposes, Quick Sync turns
off after 30 seconds of inactivity after the
activation button is pressed. After timed-out, the
user is expected to press the activation button
again to activate Quick Sync.