Installing The Control Panel-10 Hard Drive System And 24 Hard Drive System - Dell PowerEdge R630 Owner's Manual

NOTE: To locate the connectors on the system board, see the System board connectors
section.
3. Slide the control panel out of the chassis.
4. Disconnect the control panel cable from the control panel.
Figure 93. Removing the control panel for 10 and 24 hard drive system
1. control panel
3. screw
5. J_CP connector on the system board
Related Links
Safety instructions
System board jumpers and connectors
Before working inside your system
Installing the control panel–10 hard drive system and 24 hard drive system
Installing the control panel–10 hard drive system and 24 hard drive system
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. screw hole
4. cable securing clip
6. J_FP_USB connector on the system
board
169