Integrated Storage Controller Card; Removing The Integrated Storage Controller Card - Dell PowerEdge R630 Owner's Manual

Integrated storage controller card

Your system includes a dedicated expansion card slot on the system board for an integrated controller
card. The integrated storage controller card provides the integrated storage subsystem for the internal
hard drives in your system. The controller supports SAS and SATA hard drives and also enables you to set
up the hard drives in RAID configurations. The RAID configurations depend on the version of the storage
controller included with your system.

Removing the integrated storage controller card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
4. Remove the expansion card riser 1.
5. Keep the Phillips #2 screwdriver ready.
Steps
1. Loosen the screws that secure the integrated storage controller cable to the integrated storage
controller card connector on the system board.
2. Lift the integrated storage controller cable away from the integrated storage controller.
3. Lift one end of the card and angle it to disengage the card from the integrated storage controller
card holder on the system board.
4. Lift the card out of the system.
127