Dell PowerEdge R630 Owner's Manual page 16

Item Indicator, Button, or
Connector
4 NMI button
5 System identification
button
6 Micro USB port
7 Information tag
8 Hard drives (24)
9 Quick Sync
16
Icon Description
NOTE: On ACPI-compliant operating
systems, turning off the system by using the
power button causes the system to perform
a graceful shutdown before power to the
system is turned off.
Used to troubleshoot software and device driver
errors when running certain operating systems.
This button can be pressed by using the end of a
paper clip.
NOTE: Use this button only if directed to do
so by qualified support personnel or by the
operating system documentation.
The identification buttons on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the system status indicator on the back
flashes until one of the buttons is pressed again.
Press to toggle the system ID on or off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset the iDRAC (if not disabled in F2 iDRAC
setup), press and hold the button for more than
15 seconds.
Enables you to connect USB devices to the
system or provides access to the iDRAC Direct
features. For more information, see the Integrated
Dell Remote Access Controller User's Guide at
Dell.com/idracmanuals. The port is USB 3.0-
compliant.
Contains system information such as service tag,
NIC, MAC address for your reference. The
information tag is a slide-out label panel.
Up to twenty four 1.8-inch hot swappable hard
drives.
Indicates a Quick Sync enabled system. The
Quick Sync feature is optional and needs a Quick
Sync bezel. This feature allows management of
the system by using mobile devices. This feature
aggregates hardware or firmware inventory and
various system level diagnostic and error
information that can be used in troubleshooting
the system. For more information, see the