Dell PowerEdge R630 Owner's Manual page 22

Item Indicator, Button, or
Connector
2 System identification
connector
3 iDRAC8 Enterprise port
4 LP PCIe expansion card
slot (riser 1)
5 Serial connector
6 LP PCIe expansion card
slot (riser 2)
7 Video connector
8 USB port (2)
9 LP PCIe expansion card
slot (riser 3)
10 Ethernet connectors (4)
22
Icon Description
Press to toggle the system ID on and off. If the
system stops responding during POST, press and
hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup)
press and hold for more than 15 seconds.
Enables you to connect the optional system status
indicator assembly through the optional cable
management arm.
Dedicated management port.
NOTE: The port is available for use only if the
iDRAC8 Enterprise license is installed on your
system.
Enables you to connect a low profile LP PCIe
expansion card. See the Expansion card installation
guidelines section.
Enables you to connect a serial device to the
system.
Enables you to connect a low profile LP PCIe
expansion card. See the Expansion card installation
guidelines section.
Enables you to connect a VGA display to the
system.
Enables you to connect USB devices to the system.
The ports are USB 3.0-compliant.
Enables you to connect a LP PCIe expansion card.
See the Expansion card installation guidelines
section.
Four integrated 10/100/1000 Mbps NIC
connectors
or
Four integrated connectors:
• Two integrated 10/100/1000 Mbps NIC
connectors
• Two integrated 100 Mbps/1 Gbps/10 Gbps SFP
+ connectors
status indicator on the back
flashes until one of the
buttons is pressed again.