Installing The System Board - Dell PowerEdge R630 Owner's Manual

Removing a heat sink
Removing a processor
Removing the integrated storage controller card
Removing the network daughter card
Removing the optional internal dual SD module
Replacing the optional internal USB memory key
Removing a hot swappable hard drive or SSD
Removing the hard drive backplane

Installing the system board

Installing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Steps
1. Unpack the new system board assembly.
CAUTION: Do not lift the system board by holding a memory module, processor, or other
components.
CAUTION: Do not to damage the system identification button while placing the system board
into the chassis.
2. Hold the touch points and lower the system board into the chassis.
3. Push the system board toward the back of the chassis until the board is seated correctly.
177