Dell PowerEdge R630 Owner's Manual page 133

1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #1 screwdriver handy.
NOTE: If the system has three PCIe cards, ensure that you install the PCIe cooling shroud in your
system.
Steps
1. Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. To ensure that the connector on the card is in contact with the connector on the system board,
press the touch point on the card.
4. Tighten the two captive screws to secure the NDC to the system board.
5. Install the expansion card riser 3.
Figure 62. Installing the NDC
1. captive screw socket (2)
3. captive screw (2)
5. NDC
Next steps
Follow the procedure listed in the After working inside your system section.
2. connector on the system board
4. touch point (2)
6. back panel slots for Ethernet
connectors
133