Dell PowerEdge R630 Owner's Manual page 170

2. Keep the Philips #1 screwdriver ready.
Steps
1. Route the control panel cable through the chassis and connect the control panel cable to the
control panel.
2. Push the control panel into the chassis till it snaps into place.
NOTE: Ensure that the screw hole on the control panel aligns with the screw hole located at
the top of the chassis.
3. Replace the screw that secures the control panel to the chassis.
4. Locate the connectors J_CP and J_FP_USB on the system board.
NOTE: To locate the connectors on the system board, see the Jumpers and connectors
section.
5. Connect the control panel cable to the connectors on the system board (J_CP and J_FP_USB) and
the hard drive expander card.
NOTE: Ensure that the control panel cable inside the system is routed along the chassis wall
and secured by using the cable securing bracket.
Figure 94. Installing the control panel for 10 and 24 hard drive system
1. control panel
3. screw hole on the chassis
5. cable securing clip
7. J_FP_USB connector on the system
board
170
2. screw hole on the control panel
4. screw
6. J_CP connector on the system board