Dell PowerEdge R630 Owner's Manual page 20

Item Indicator, Button, or
Connector
2 System identification
connector
3 iDRAC8 Enterprise port
4 PCIe expansion card slot
(riser 1)
5 Serial connector
6 Video connector
7 USB ports (2)
8 PCIe expansion card slot
(riser 2)
9 Ethernet connectors (4)
10 PSU1
11 PSU2
20
Icon Description
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold for more than 15 seconds.
Enables you to connect the optional system status
indicator assembly through the optional cable
management arm.
Dedicated management port.
NOTE: The port is available for use only if the
iDRAC8 Enterprise license is installed on your
system.
Enables you to connect a low profile PCIe
expansion card. See the Expansion card installation
guidelines section.
Enables you to connect a serial device to the
system.
Enables you to connect a VGA display to the
system.
Enables you to connect USB devices to the system.
The ports are USB 3.0-compliant.
Enables you to connect a full height three-fourth
length PCIe expansion card. See the Expansion
card installation guidelines section.
Four integrated 10/100/1000 Mbps NIC
connectors
or
Four integrated connectors:
• Two integrated 10/100/1000 Mbps NIC
connectors
• Two integrated 100 Mbps/1 Gbps/10 Gbps SFP
+ connectors
or
• Four 10 Gbps
• Two 495 W, 750 W, or 1100 W AC power supply
units (PSUs)
Or
• Two 1100 W DC PSUs
Or
• Two 750 W mixed mode PSUs
• Two 495 W, 750 W, or 1100 W AC PSUs
Or
• Two 1100 W DC PSUs