Dell PowerEdge R630 Owner's Manual page 166

Steps
1. Disconnect the display module cable from the control panel board.
2. Remove the screw (located at the top of the chassis) that secures the control panel to the chassis.
CAUTION: Applying excessive force while pulling upward may damage the control panel.
NOTE: Apart from the screw, the control panel has three tabs (one on the left and two tabs on
top) that secure it to the chassis.
3. Hold the top edge of the control panel at the corners and pull upward until the control panel tabs are
released.
4. Hold the right edge of the control panel and rotate it toward the left until it is released from the
chassis.
5. Pull the control panel away from the chassis.
Figure 91. Removing the control panel for eight hard drive system
1. control panel
3. display module ZIF connector
Related Links
Safety instructions
Before working inside your system
Installing the control panel–eight hard drive system
166
2. notch on chassis front wall (2)
4. display module cable