Removing The Control Panel-10 Hard-Drive And 24-Hard Drive System - Dell PowerEdge R630 Owner's Manual

CAUTION: The display module connector is a ZIF (zero insertion force) connector. Ensure
that the locking tab on the connector is released before removal and insertion. The locking
tab must be engaged after insertion.
5. Connect the display module cable to the control panel board.
Next steps
Follow the procedure listed in
Removing the control panel–10 hard–drive and 24–hard drive system
Prerequisites
1. Ensure that you read the
2. Follow the procedure listed in
3. Keep the #1 Philips screwdriver ready.
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
1. Using a #1 Philips screwdriver, remove the screw (located at the bottom of the chassis) that secures
the control panel to the chassis.
2. Remove the control panel cable from the connectors on the system board (J_CP and J_FP_USB) and
the hard-drive expander card.
NOTE: To locate the connectors on the system board, see System Board Connectors.
3. Press the control panel latch and slide the control panel out of the chassis.
4. Disconnect the control panel cable from the control panel.
118
After working inside your
Safety instructions.
Before working inside your
system.
system.