Nic Ports; Serial Connector; Vga Ports; Internal Dual Sd Module - Dell PowerEdge R630 Owner's Manual

NIC ports

The PowerEdge R630 system supports four Network Interface Controller (NIC) ports on the back panel,
which is available in one of the following three NIC configurations:
• Four 10/100/1000 Mbps
• Two 10/100/1000 Mbps and two 100 Mbps/1 Gbps/10 Gbps
• Four 10 Gbps

Serial connector

The serial connector connects a serial device to the system. The PowerEdge R630 system supports one
serial connector on the back panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-
compliant.

VGA ports

The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The PowerEdge
R630 system supports two 15-pin VGA ports on the front and back panels.

Internal Dual SD Module

The PowerEdge R630 system supports two optional flash memory card slots with an internal dual SD
module.
NOTE: One card slot is dedicated for redundancy.

Video specifications

The PowerEdge R630 system supports Integrated VGA controller with 16 MB capacity.
Table 23. Resolution information for video modes
Resolution
640 X 480
800 X 600
1024 X 768
1152 X 864
1280 X 1024
1440 X 900

Environmental specifications

NOTE: For additional information about environmental measurements for specific system
configurations, see Dell.com/environmental_datasheets.
Refresh rate (Hz)
60, 70
60, 75, 85
60, 75, 85
60, 75, 85
60, 75
60
Color depth (bit)
8, 16, 32
8, 16, 32
8, 16, 32
8, 16, 32
8, 16, 32
8, 16, 32
41