Connections And Settings; Connections For Using The Application Software - Sony PDW-HR1 Operation Manual

Connections and
Settings
Note
Production of some of the peripherals and related devices
described in this chapter may have been discontinued.
For advice about choosing devices, please contact your
Sony dealer or a Sony sales representative.
Connections for using the
application software
Download and install the dedicated application software.
For details about downloading application software, see
"Software Downloads" (page 190).
Using the (network) connector (FTP
connection)
The following shows an example of an FTP (File Transfer
Protocol) connection.
Note
The PDW-HR1 IP address and other network-related
settings are required for connections.
For details of the network-related settings, see "To change
network settings" (page 169).
Connecting this unit directly to a laptop computer
PDW-HR1 (this unit)
To (network) connector
Network cable (not supplied)
Settings on this unit
Remote control switch: NET (see page 23)
Setup menu item 257 NETWORK ENABLE: net
44

Connections and Settings

Connecting three PDW-HR1 units to a laptop
computer via a LAN
PDW-HR1
Settings on all PDW-HR1
Remote control switch: NET (see page 23)
Setup menu item 257 NETWORK ENABLE: net
Using the
(FAM connection)
The following shows an example of a FAM (file access
mode) connection.
Laptop computer
Note
The FAM driver must be installed in advance.
See "To install the FAM driver" (page 130 or 132) for
more information about installing the FAM driver.
Some limitations apply to FAM connections. For details,
see "File Operations in File Access Mode (for Windows)"
(page 130).
To (network)
connector
(i.LINK) S400 FAM connector
Laptop computer
Network cable
(not supplied)