Sony PDW-HR1 Operation Manual page 185

Alarm message in GUI screen
NO OPTION INSTALLED.
FUNCTION IS NOT AVAILABLE IN
VOICE MODE.
AUDIO FORMATS ARE DIFFERENT.
SYSTEM FREQUENCIES ARE
DIFFERENT.
VOICE IS NOT SET ON RIGHT CH.
CANNOT BE EXECUTED DURING PULL
DOWN MODE.
REVIEW CAN NOT BE EXECUTED.
REVIEW WAS NOT COMPLETED.
Alarms relating to audio and video signals
Alarm message in time Alarm message in video monitor screen Action
data display area
a) INPUT VIDEO IS NOT DETECTED.
No INPUT!
CHECK THE VIDEO INPUT MODE AND
SUPPLY A VIDEO SIGNAL TO VIDEO
INPUT.
INPUT AUDIO EMPHASIS IS NOT
a)
EMPHASIS!
SUPPORTED.
CHECK THE EMPHASIS OF THE AUDIO
INPUT SIGNAL.
REF NON-STD A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
"on".
Alarms relating to sensors and drives
Alarm message in time
data display area
FAN Stopped
DR-FAN Stop
High TEMP!
HUMID!
BATT EMPTY!
Description/action
An editing operation was attempted with no option installed.
To edit, install the PDBZ-UPG03 Software Upgrade Key, or install the PDBK-MK1
option board.
An attempt was made to expand the display of voice data, or a menu item that
cannot be used to edit voice data was selected.
An edit point was set in a clip with an audio format that differs from that of this unit,
on the player or the recorder. Or, the audio formats of the player and recorder are
different.
Set the edit point in a clip with the same audio format. Or, select the same audio
format settings on the player and recorder.
An edit point was set in a clip with a system frequency that differs from that of this
unit.
Set the edit point in a clip with the same system frequency.
An attempt was made to execute voice over editing on a channel that is not present
in the material.
Execute the edit on a channel that is present in the material (channels 1 to 4 in the
case of 4-channel material).
An attempt was made to edit a clip during playback in pull down mode.
Pull down clips cannot be edited.
An attempt was made to conduct a review before execution of an AUTO EDIT.
Wait until the AUTO EDIT finishes, and then press the PREVIEW button while
holding down the SHIFT button.
A review failed.
This appears when a review could not be executed.
Alarm message in video monitor screen Action
FAN MOTOR STOPPED.
DRIVE FAN MOTOR STOPPED.
HIGH TEMPERATURE.
HIGH TEMPERATURE IN DRIVE.
MOISTURE HAS BEEN DETECTED.
BATTERY EMPTY!
• Check the setting of V INPUT on Page P1 VIDEO of
the function menu (see page 57).
• Input the signal selected in V INPUT on page P1
VIDEO of the function menu.
Check the emphasis of the audio input signal.
Input a standard signal.
Contact a Sony service representative.
Note
The unit will not stop operating, but if you continue to
use it in this state temperatures inside the unit or the
drive will rise, possibly resulting in failure or fire.
Stop recording or playback, power the unit off and on
again, and wait until the HUMID display disappears.
Change the battery.
185
Troubleshooting