Sony PDW-HR1 Operation Manual page 117

To select clips from a thumbnail list
Switch to thumbnail display by pressing the
THUMBNAIL button, and then select a clip. Next,
press the PUSH SET knob or the SET button to return
to the viewer display.
Note
When PLAYER SEL is set to "external" in the Edit
Menu, you can select a clip from the thumbnail list if
the connected device is a PDW-series device only.
5
Use the PLAY, PAUSE, and STOP buttons and the
shuttle/jog dial to play the clip, and set edit points in
the clip.
To enlarge or reduce the scale of the timeline
Press the + TRIM or – TRIM button.
To set In or Out points
With the IN or OUT button held down, press the
ENTRY button.
To jump to In or Out points
With the IN or OUT button held down, press the
GOTO button.
To adjust the positions of In or Out points
With the IN or OUT button held down, press the
– TRIM or + TRIM button.
To delete In or Out points
With the IN or OUT button held down, press the
DELETE button.
To recall a deleted In point or Out point
Press the RECALL button with the IN button or OUT
button held down.
6
Press the RECORDER button.
The screen changes to the RECORDER mode screen,
and sub clips in the edit list that was loaded in step 2
appear.
When there are no sub clips
Sub clips are not displayed when a new edit list is
loaded and when no edit list is loaded.
7
Select EDIT MODE in the Edit Menu to select the
editing mode (see page 115).
8
Use the PLAY, PAUSE, and STOP buttons and the
shuttle/jog dial to play the edit list, and set edit points
in the edit list (see step 5).
When there are no sub clips
This operation is not needed, because edit points
cannot be set.
If you skip setting edit points
The material is added at the playline position.
To enlarge or reduce the scale of the timeline
Press the + TRIM or – TRIM button.
To modify audio transitions at edit points
Select EDIT POINT in the Edit Menu, and then select
"cut"or "fade" (fade out and fade in).
Note
Depending on the combination of edit mode and edit
point settings, it may not be possible to execute the
edit. In this case, the DELETE button flashes. Delete
one of the edit points, and check that the DELETE
button is not lit.
9
Press the PREVIEW button.
The editing screen changes to a full-screen viewer,
which plays the edit section, including the preroll and
postroll sections.
To reset edit points, repeat steps 5 to 9.
Preview execution range
The following figure shows the preview execution
range for an example in which In and Out points were
set in material C0225, and then material C0225 was
inserted into sub clip C0002.
1 Preview execution range
1)
2 Preroll time
3 Postroll time
1) When PLAYER SEL in the Edit Menu is set to "disc(clip)",
"disc(voice)" or "SxS": 3 seconds
When PLAYER SEL in the Edit Menu is set to "external": The time
specified by P-ROLL TIME in the Edit Menu.
Note
When PLAYER SEL in the Edit Menu is set to
"external" and EDIT MODE is set to "insert", the
postroll section is not played.
10
Press the AUTO EDIT button.
The clip range specified in step 5 is added to the edit
list in the edit mode specified in step 7, and the
updated edit list is saved automatically.
117
Editing Operations