Sony PDW-HR1 Operation Manual page 150

Menu items in the 100s, relating to the control panels (OPERATIONAL PARAMETER)
Item number Item name
153 FIND MODE
154 SINGLE CLIP PLAY MODE
a) The disc is ejected after recording stops.
Menu items in the 200s, relating to the remote control interface (REMOTE INTERFACE)
Item number Item name
201 PARA RUN
214 REMOTE INTERFACE
257 NETWORK ENABLE
a) When the PDBK-202 option board is installed
Item number Item name
301 VAR SPEED RANGE FOR
SYNCHRONIZATION
307 AUTO-DELETION FOR
INCONSISTENT DATA
150
Setup Menu
Settings
Specify the frame to be cued up when the PREV or NEXT button is
pressed.
clip: The first frame of the clip
R.ST (clip & rec start mark): The frame where a Rec Start essence
Put the unit into single clip playback mode, or exit from single clip
playback mode.
off: Exits from single clip playback mode. (Puts the unit into continuous
on: Puts the unit into single clip playback mode.
Settings
Select whether to use synchronized operation for two or more VTRs.
dis (disable): No synchronized operation
ena (enable): Use synchronized operation
Note
To use synchronized operation for two or more VTRs, set item 201 to ena
on all of the VTRs.
When the remote control switch is set to REMOTE, select the device
from which to remote-control this unit.
9PIN: Device connected to the REMOTE(9P) connector.
SDI: Device connected to the SD/HDSDI INPUT connector.
i.LINK: Device connected to the
Select the remote control switch positions which enable network
connections.
net (network): Only when the switch is set to "NET".
n&9P (network & remote(9PIN)): When the switch is set to "NET", and
Menu items in the 300s, relating to editing operations (EDITING)
Settings
Select the playback speed range when carrying out playback in variable
speed mode from a remote control unit connected to the REMOTE(9P)
connector.
–1~+1: –1 to +1 times normal speed.
wide: –1.20 to +1.20 times normal speed.
Select what to do when an inconsistent edit point has been set.
manu (manual): Flash the DELETE button on the control panel and
neg&E (neg & excess): Delete the inconsistent edit point automatically
neg: Delete the inconsistent edit point automatically when an Out point
mark is set (if no essence mark is set, the first frame of the clip)
playback mode.)
b) The unit enters stop mode when the PLAY button is pressed. It enters
freeze picture mode (jog, shuttle, or variable mode) when the SHUTTLE/
JOG button or VAR/JOG button is pressed.
when the switch is set to "REMOTE" and setup menu item 214 is set
b)
to "9PIN".
b) FTP connections can be made only when the device connected to the
REMOTE(9P) connector (D-sub 9 pin) is in stop mode. During FTP
connections, the device connected to the REMOTE(9P) connector cannot
be used to control this unit.
display a warning.
when an Out point is set before an In point, and when more edit
points than necessary have been set.
is set before an In point. Flash the DELETE button on the control
panel and display a warning when more edit points than necessary
have been set.
a)
(i.LINK) HDV TS connector.