Sony PDW-HR1 Operation Manual page 169

To change a menu item setting
Carry out the following operations to change the setting.
For information about how to change network settings see
next section "To change network settings".
Function buttons (F1 to F6)
BPAGE and PAGEb buttons
HOME button
V/MARK1 button and v/MARK2 button
1
Use the PUSH SET knob or the V/MARK1 and v/
MARK2 buttons to select the required item, then press
the PUSH SET knob or the SELECT function button
(F2).
The sub-items of the selected item appears.
2
Select a sub-item with the same operation as step 1,
and use the PUSH SET knob or the V/MARK1 and v/
MARK2 buttons to change the setting.
3
Press the PUSH SET knob or the SELECT function
button (F2) to confirm the setting change.
4
Press the SAVE function button (F5).
The message "NOW SAVING..." appears on the video
monitor display, and "Saving..." appears in the time
data display area, while the new settings are saved in
memory. When the saving operation is completed, the
video monitor display and the time data display area
return to their normal indications.
To cancel changing a setting
Before pressing the SAVE function button (F5), press the
MENU button.
The menu disappears from the video monitor display,
without saving the new setting.
MENU button
PUSH SET knob
SHIFT button
B button and b button
To change network settings
To change network settings, carry out the procedure
described in the previous section, "To display the
maintenance menu", to display the NETWORK menu
item, then carry out the following operations.
For details of the settings, consult your network
administrator.
When the IP address is assigned automatically
Note
Check that the network cable is connected to this unit
before carrying out the operation.
Follow the procedure as shown in previous section "To
change a menu item setting" to set maintenance menu item
M5: NETWORK >M50: DHCP to "ENABLE".
To check the assigned IP address
Select maintenance menu item M5: NETWORK
>M51: IP ADDRESS PRESET.
Note
If the IP address cannot be assigned, this is shown as
"000.000.000.000." In this case, consult the network
administrator.
To set the IP address
First set DHCP to "DISABLE" (see the previous section,
"When the IP address is assigned automatically").
1
Select maintenance menu item M5: NETWORK
>M51: IP ADDRESS PRESET.
2
Press the PUSH SET knob.
The IP address appears, and the digit that can be
changed flashes.
3
Set the IP address.
To select a different digit to be changed
Use the B and b buttons.
To change the value of a digit
Turn the PUSH SET knob.
Turning clockwise increases the value, and turning
counterclockwise decreases the value.
The V/MARK1 and v/MARK2 buttons can be used.
To return to the factory default setting
Press the RESET button.
4
When all digits are set, press the SAVE function
button (F5).
169
Maintenance Menu