Entry Button; Video Processing Settings Section - Sony PDW-HR1 Operation Manual

h UNDO button
Undoes the immediately preceding operation.
i IN (set IN point) and OUT (set OUT point) buttons
This buttons light when an In or Out point is set.
When either button is pressed alone, the timecode of the In
or Out point appears. ("--:--:--:--" appears if the
corresponding point has not been set.)
The IN and OUT buttons are used with the following
buttons to execute the indicated functions.
Button Function
ENTRY Set In and Out points
–/+ TRIM Trim In and Out points
DELETE Delete In and Out points
RECALL Recall deleted In and Out points
GOTO Go to In and Out points
j ENTRY button
When pressed with the IN or OUT button held down, sets
an In or Out point at the current location in a clip or sub
clip.

7 Video processing settings section

1 VIDEO PROCESS CONTROL switch
a VIDEO PROCESS CONTROL switch
Selects the settings that control the unit's internal digital
video processor.
LOCAL: Settings made with the unit's VIDEO,
CHROMA, HUE/CHROMA-PHASE, and SETUP/
BLACK switches and adjustment knobs.
MENU: Settings made with the setup menu.
28
Control Panel
2 VIDEO switch and adjustment knob
3 CHROMA switch and adjustment knob
5 SETUP/BLACK switch and adjustment knob
6 OPERATION and ACCESS indicators
and PHONES jack
1 OPERATION indicator
3 PHONES jack
a OPERATION indicator
Lights in green when this unit is operating.
Lights in red when this unit is recording.
b ACCESS indicator
Has the same function as the ACCESS indicator on the
control panel (see page 22).
c PHONES jack
Stereo jack for connection of stereo headphones for
monitoring of audio during recording, playback, and
editing. (Non-audio signals are muted.) Select the channels
to monitor with the AUDIO MONITOR SELECT buttons.
4 HUE/CHROMA-PHASE switch and adjustment knob
b VIDEO switch and adjustment knob
Set the video signal output levels for HD and SD output.
PRE: Regardless of manual settings, set the video signal
output levels to the standard levels.
VAR: Adjust the video signal output levels within the
range – ∞ to +3 dB by turning the adjustment knob.
2 ACCESS indicator